Specfications: Low Profile. Titanium Nitride. 50 ohm Impedance. Designed to be easily connected into a bredboard for rapid development. Critical component for Atlas Scientific Micro Probes.

Specifications: 5 Pack of Male BNC to Male SMA Connecter. 75 ohm impedance. Work with all Atlas Scientific Probes.

Specifications: 5 Pack of Female BNC to Female SMA Connecter. 75ohm impedance. Work with all Atlas Scientific Probes.

Specifications: 5 Pack of Female BNC to Female SMA Connecter. 75ohm impedance. Work with all Atlas Scientific Probes.

Specifications: 5 Pack of Male SMA to Male SMA Connecter. 75ohm impedance. Work with all Atlas Scientific Probes.

Specifications: 5 Pack of Female SMA to Female SMA Connecter. 75ohm impedance. Work with all Atlas Scientific Probes.

The Atlas Scientific sensor Bridge allow you to connect 4 more senser or Pumps to yours systems.Wire your power,Ground,and IC2 directly into the Screw terminals,and your sensors into the header pins.This Board includes pull up resistors...

Atlas Scientific Zero Dissolved Oxygen Calibration Solution is guaranteed not to have any oxygen in it. This stuff is great for calibrating the low end of the Dissolved Oxygen scale or to confirm that your Dissolved Oxygen probe is...

Atlas Scientific Zero Dissolved Oxygen Calibration Solution is guaranteed not to have any oxygen in it. This stuff is great for calibrating the low end of the Dissolved Oxygen scale or to confirm that your Dissolved Oxygen probe is...

If you are looking for a fast and easy way to read multiple sensors from an Arduino, the Whitebox T1 is for you. The Whitebox T1 eliminates the need for wiring, multiplexing and electrical isolation. Because it’s an Arduino Shield, it...

There’s a ton of different ways to read water level. Pressure sensors give you high accuracy; ultrasonic sensors are contact-free but, the simplicity and low cost of a float switch can’t be beat. Sure, there are a lot of crappy float...

Atlas Scientific ORP calibration solution, also know as Zobells solution maintains a constant 225mv, perfect for ORP probe calibration. Storing it below 16°C or 60°F will greatly extend its shelf life. Specifications: • ORP 225mV...