Close filters
  •  
from to
No results were found for the filter!
Navio2 Board
Navio2 Board
Autopilot HAT for Raspberry Pi powered by ArduPilot and ROS — Navio2 — Connector for RPi — 4x spacers — 8x M2.5 screws Turn your Raspberry Pi® into a drone controller GNSS receiver Tracks GPS, GLONASS, Beidou, Galileo and SBAS...
₹ 21,669.00 *
Reach RS+
Reach RS+
RTK GNSS receiver with an app as a controller Centimeter accuracy for surveying, mapping and data collection. GNSS GPS, GLONASS, BeiDou, Galileo, QZSS and SBAS Long range radio LoRa 868/915 MHz, range up to 8 km 30 hours battery life...
₹ 1,03,069.00 *
Reach RS+ Cable 2M With DB9 Female Connector
Reach RS+ Cable 2M With DB9 Female Connector
Reach RS+ Cable 2M With DB9 Female Connector Compatible with the original Reach RS.
₹ 4,899.00 *
Reach RS+ Cable 2M w/o 2nd Connector
Reach RS+ Cable 2M w/o 2nd Connector
Reach RS+ Cable 2M w/o 2nd Connector Compatible with the original Reach RS.
₹ 3,999.00 *
Reach RS+ Cable 2M With DB9 Male Connector
Reach RS+ Cable 2M With DB9 Male Connector
Reach RS+ Cable 2M With DB9 Male Connector Compatible with the original Reach RS.
₹ 4,899.00 *
Reach M+ Antenna Extention Cable 2M
Reach M+ Antenna Extention Cable 2M
Reach M+ Antenna Extention Cable 2M Compatible with the original Reach module.
₹ 1,549.00 *
Reach M+ TNC Antenna Adapter Cable 2M
Reach M+ TNC Antenna Adapter Cable 2M
Reach M+ TNC Antenna Adapter Cable 2M Compatible with the original Reach module.
₹ 1,809.00 *
Tallysman Multi-GNSS Antenna
Tallysman Multi-GNSS Antenna
Tallysman TW4721 is a compact, wideband Accutenna™ technology GNSS antenna that provides accurate reception for all upper L- band GPS, GLONASS, Beidou, and Galileo signals (L1, G1, B1, B1 BOC, B12, E1) and associated augmentation signals...
₹ 7,739.00 *
Navio2 GPS/GNSS Antenna MCX
Navio2 GPS/GNSS Antenna MCX
This antenna is not compatible with NEO6-T USB dongle. Antenna type: active (LNA built-in) Supported navigation satellite systems: GPS, GLONASS Dimensions: 45 x 35 x 15 mm Cable length: 300 mm Connector type: MCX Mounting: adhesive...
₹ 1,549.00 *
Power Module For Navio2
Power Module For Navio2
Supports LiPo batteries up to 6S Max current sensing: 60 A* Switching regulator output: 5.3 V 2.25 A 6-pos DF13 cable for connection to Navio2 power port *power module can sense current up to 90A if different connectors are used (XT60...
₹ 2,069.00 *
Wire Pack For Navio2
Wire Pack For Navio2
Includes : 2xDF13 6-pin to 2.54 mm female jumpers for UART and ADC ports 1xDF13 4-pin to 2.54 mm female jumpers for I2C port Wire length: 200 mm.
₹ 1,159.00 *
Viewed